7-11-2023 Q&A: 3D Toolpaths, Designing, Bit Evaluation, Epoxy Staining, and Vectric Techniques

During our enlightening Q&A Meetup on July 11th, enthusiasts explored the depths of CNC machining and Vectric software's capabilities, from resolving 3D finish toolpath dilemmas to mastering two-sided 3D carving. Participants exchanged knowledge on enhancing toolpath alignments, the nuances of material finishes, and the art of editing 3D models within Aspire. The session also tackled practical concerns like tool sharpness and innovative project techniques, including numbering for cribbage boards and optimizing scoreboard toolpaths. This gathering underscored the community's dedication to collaborative problem-solving and pushing the boundaries of creative CNC projects, marking another successful meetup filled with valuable insights and shared experiences.

Questions Answered in this Q&A:

• 00:01:14 - The quarter-inch end mill cuts fine, but the eighth and sixteenth-inch bits have issues.
• 00:14:07 - How to make 3d files like this?
• 00:24:01 - Can you review the toolpaths on this scoreboard file?
• 00:33:33 - Is there an easier way to do the numbers on this cribbage board?
• 00:42:34 - What you use for a rule of thumb to know when your bits getting too dull to use?
• 00:47:46 - Did you say you could modify a 3D imported object in Vectric?
• 01:00:26 - Help with file and x molding y.
• 01:04:04 - Any experience with a downcut v bit?
• 01:04:50 - Can we carve this 3d model using two sided?
• 01:08:40 - Is it common for the epoxy To look tinted when you apply stain over it?

Keywords:

3d finish toolpath, end mill issues, Vectric software, molding toolpath, toolpath alignment, x molding y, downcut v bit, two-sided 3d carving, epoxy staining, spoon model editing, Aspire modifications, tool sharpness, composite nails, cribbage board numbering, scoreboard toolpaths